STM LED driver handles in-vehicle electrical fluctuations

STM LED driver handles interior and exterior lighting

ST Microelectronics has introduced a single-chip automotive LED driver with integrated DC-DC converter for reducing costs, increasing design flexibility and keeping lighting intensity consistent as electrical conditions within a vehicle fluctuate.

Suitable for exterior lighting such as daytime running lights, headlights, rear lights, stop lights and turn signals, as well as interior lighting, the ALED6000 drives a single string of LEDs at up to 3A and has an input-voltage range of 4.5 to 61V.

It implements digital dimming and has a dedicated pin to apply the PWM control signal. There is also an enable pin and a sync pin that ensure low noise in multi-device applications.

The output current is accurate within 3.2% and is monitored with a sense resistor that has a typical voltage drop of 250mV. The quiescent current is 2.4mA in operation and 11µA in shutdown.

Also featuring a Vbias auxiliary-input pin and pulse-skipping operation at light load, the device can ensure high efficiency across the load range.

The on-chip converter allows buck, buck-boost and floating-boost topologies, giving flexibility to power LED strings that require a voltage above or below the input voltage while also handling supply fluctuations. In addition, the converter can operate in low-dropout mode with close-to 100% duty cycle if the input voltage falls near or below the programmed output.

In the event of over-current, it invokes pulse-by-pulse protection to limit the output current at the pre-set maximum. There is also programmable soft-start circuitry to limit inrush current, and thermal protection with auto-recovery.

Both the output-current limit and converter switching frequency can be selected using external components, allowing the inductor to be optimised for high energy efficiency, fast dynamic response, small size and low output ripple with a low-ESR capacitor.

AEC-Q100 qualified, the automotive LED driver is in production now in the HTssop-16 package. Designers can jump-start their projects using the STeval-ILL089V1 evaluation kit.

www.st.com

 

Recommend to Colleagues: