Infineon to present Can FD transceivers at Electronica

At next week’s Electronica show in Munich, Infineon will be presenting its TLE925x Can FD transceivers that are said to make data exchange up to 30 times faster than today.
Around 60 electronic control units communicate with each other in vehicles today via the Can bus. The need for in-vehicle communications is growing as the amount of networking increases and more comfort and automation are implemented.
The protocol variant Can FD (Can Flexible Data rate) allows a higher data bandwidth and transmission speed. This saves time in programming, in tests and diagnostic routines as well as for software updates over the air.
The TLE925x reaches transmission speeds of up to 5Mbit/s. Compared with the classical Can transceivers with a maximum of 8byte, the Can FD transceivers can send a payload of up to 64byte per message. This opens up the possibility to check the transmitted data for consistency in the transmitting control unit and to sign it with a 21bit checksum instead of the 17bit possible so far.
Longer checksums increase communications reliability between the control units. This makes it possible to secure data transmission in the vehicle without the application software becoming more complex in the electronic control unit.
The Can FD transceivers are used, for example, in body control modules and gateways, in power steering, engine and transmission control units as well as in radar and camera-based driver assistance systems. On average, every vehicle today has 17 Can transceivers. The number should rise to more than 20 within the next five years.
The TLE925x permits an interface voltage to the microcontroller of 3.3V as well as 5V to improve signal symmetry. The more symmetrical the signals, the better the EMC. Compared with the previous Can generation, Infineon says it has improved the robustness of the Can FD transceivers to EMI in the standard frequency range of 1MHz to 1GHz.
The electromagnetic emission of the device between 150kHz and 1GHz is claimed to be lower than in any other Can transceiver available today. At the same time the transceivers pass electrostatic discharge tests (ESD) of at least ±8kV according to IEC61000-4-2.
For Can FD with 5 Mbit/s, the company sells, apart from the TLE925x transceivers compliant to ISO11898-2:2016, the matching system basis chips in the TLE9278 multi-Can power-SBC family. The TC3xx multicore microcontrollers in the Aurix family have up to 12 Can FD channels according to ISO 11898-1:2015.
The TLE925x family is available in sample quantities in the RoHS-compatible DSO-8 standard package or in the TSON-8 with dimensions of 3 by 3mm. Volume production is due to start in February 2017.
